Apollo Intelligent Meter Series IMY Manual do Utilizador descarregar pdf (Página 8)

PROGRAMMING AND OPERATING THE IMY

PROGRAMMING THE IMY

Although the unit has been programmed at the factory, the set-ups will

generally have to be changed to suit the application. Basic set-up is complete

after selection of the temperature units, decimal point placement, and

selection of the digital filtering level.

Before actually trying to program the indicator, it is advised to organize all

the data for the programming steps to avoid any possible confusion and to

read the programming procedure entirely before proceeding.

To set-up the indicator, connect primary power and signal wires as

outlined in the connections section (Appendix “A”). Remove the jumper

wire (if installed) from TBA #3 (PGM. DIS.). This will allow the operator to

enter and modify all of the indicator’s parameters. Press the front panel

button labeled “P”, momentarily. Briefly, the display will show “Pro”

alternately flashing with “0”. This is the indicator’s programming mode.

The programming mode is divided into sections, numbered 0-9, each of

which can be individually accessed. The front panel “UP” and “DOWN”

arrow buttons can be used to select one of these numbers and the “P” button

can be used to enter the selected programming module. In all of the

programming modules, “UP” and “DOWN” are used to either select from a

list of choices or enter a value. The “P” button is used to save the new value

and progress to the next step within a module (Note: the new value takes

effect when “P” is pressed). Upon completion of a module, the indicator

returns to the “Pro” <>“0” stage. Pressing the “P” button at this time

causes the unit to display “End” after which the unit returns to the normal

display mode. The following table explains the basic function of each step.

Note: < > This indicates that the display will alternate between the English

prompt and the actual data.

-6-

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Sem comentários

Apollo Intelligent Meter Series IMY Manual do Utilizador Página 8