Apollo SL Manual de Instalação descarregar pdf (Página 30)

Installation

22 Apollo SL50 / SL60 Installation Manual

POST INSTALLATION CHECKOUT

Once the unit is installed, complete the checkout procedure to verify proper operation. Refer

to the User’s Guide for operating instructions.

The steps that are not applicable to a particular installation may be skipped. A checkout log

sheet is included on page 27 to fill out during the checkout procedure. Make a photocopy of

the log sheet for ease of use if desired.

The checkout procedure is broken into several groups. The GPS Navigation Checkout, VHF

Comm Checkout (SL60), and the Final System Check should be completed with the aircraft

moved clear of hangers and other structures.

Mounting / Wiring Check

Verify that all cables are properly secured and shields are connected to the rear of the

mounting frame. Check the movement of the aircraft controls to verify that there is no

interference.

TEST MODE CHECKOUT AND SETUP

The SL50/60 has a built-in test mode to simplify the checkout. To operate the SL50 in the test

mode, hold down the WPT and MSG buttons while switching on the power. For the SL60, hold

down the COM and MSG buttons. To return to normal operation, switch the power off, then

back on.

Avionics Outputs

Check the avionics output connections by using the test mode as follows. Rotate the LARGE

knob to select each test.

1. Using the “CDI TRIANGLE” page, rotate the SMALL knob to check left, mid, and right.

2. Using the “TO/FROM FLAG” page, rotate the SMALL knob to check the Off, To, and From

outputs.

3. Using the “LAMP OUTPUTS” page, rotate the SMALL knob to check all the connected

annunciators.

4. Using the “V

ALID FLAG PAGES” page, rotate the SMALL knob to check all the connected

valid flag outputs.

Installation Configuration

The SL50/60 must be configured to match the operation supported by the installation. This

includes IFR and VFR operation selections.

1. In test mode, rotate the

LARGE knob to the “OPTIONS:” page.

2. Press SEL, rotate the SMALL knob to select VFR (IFR? NO) or IFR (IFR? YES) operation,

then press

ENT when complete.

Note: Make sure that all installation requirements are complete for the selected operation.

Refer to the System Configurations section on page 4 for installation requirements.

Serial Interface Configuration

The SL50/60 RS-232 serial port can be configured for several different input and output

formats. To select the serial port configurations:

1. In test mode, rotate the

LARGE knob to the serial port configuration “SERIAL PORT” page.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 61 62

Comentários a estes Manuais

Sem comentários

Apollo SL Manual de Instalação Página 30

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de navegação Apollo SL